LC (Lucent Connector) is one of the most widely adopted fiber optic interfaces in the world today. It covers LC connectors, LC patch cables, uniboot designs, armored and ultra-low-loss variants, LC adapters and patch panels, LC attenuators, MTP/MPO-to-LC cassettes, LC-interfaced transceivers, and LC media converters. Multi-fibre cables usually with 12 or 24 fibers end on 12-fiber MPO/MTP® connectors.
Read More
The typical optical modulation that are used include Dual Polarization Quadrature Phase Shift Keying (DP-QPSK) and QAM-16. These modules put the DSP on the module and use a conventional retimed digital interface. Eliminating local loops makes data exchange more secure while a ters house an MMR. Both approaches cater to specific use cases, and their selection depends on factors such as performance requirements, deployment flexibility, and cost considerations. Passive Optical Network (PON) design gives you the flexibility to right-size connectivity across the enterprise LAN – inside buildings and across an extended campus. High-bandwidth networking was historically limited to long haul telecom networks. An optical module is a typically hot-pluggable optical transceiver used in high-bandwidth data communications applications.
Read More
Structured cabling is the design and installation of a cabling system that will support multiple hardware uses and be suitable for today's needs and those of the future.
Read More
Relay protection is the discipline of designing schemes that detect faults, coordinate relays, and isolate equipment without outages. Protective relays and devices have been developed over 100 years ago to provide "lastline"of defense for the electrical systems. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions.
Read More
Abstract−To avoid undesirable disconnection of healthy wind generators (WGs) or a wind power plant, a WG protection relay should discriminate among faults, so that it can operate instantaneously for WG, connected feeder or connection bus faults, it can operate after a. For those not familiar with the different elements that form a WEP, commonly known as a Wind Farm, this report introduces a description of the different elements comprising a wind farm and how their unique characteristics may be considered to provide a proper design. First, the amplitude and attenuation characteristics of short circuit current in different types of wind turbines are analyzed, as well as the contributing factors to short-circuit current in wind farms. Protection of Wind Electric Plants is a report covering engineering considerations for the design of protection systems and present relay protection and coordination practices at wind electric plants. Abstract—A wind electric plant (WEP) is made of many wind turbine generators spread over a large area and includes many subsystems that need to be protected.
Read More+48 22 538 72 19
ul. Postępu 14, 02-676 Warszawa, Poland