This portable relay protection tester is designed for comprehensive testing and calibration of various protection relays. The instrument simulates fault conditions and analyzes relay performance, ensuring the reliability and accuracy of protection systems. The SVERKER750 can be used to test a wide variety of equipment, including overcurrent relays, inverse time overcurrent relays, undercurrent relays, ground fault relays, directional overcurrent.
Read More
The insulation resistance test is completed in line with IEC 60255-27, i. The testing and verification of relay protection devices can be divided into four groups: Type tests are needed to prove that a protection relay meets the claimed specification and follows all relevant standards. Mechanical relays rely on an electromagnetic coil and movable contacts, whereas solid-state relays use semiconductor devices. Power System protection is crucial part of power station and substations safety which use protection relays and circuit breakers to isolate faulty parts or zones within the plant including Generator zone, Motor zone, Feeder zone, Bus zone, Transformer zone and Transmission Lines zone.
Read More
An overcurrent relay is a type of protective relay which operates when the load current exceeds a pickup value. It is of two types: instantaneous over current (IOC) relay and definite time overcurrent (DTOC) relay. Electromechanical relays can be classified into several different types as follows: "Armature"-type relays have a pivoted lever supported on a hinge or knife-edge pivot, which carries a moving contact.
Read More
Relay coordination refers to setting protective devices so that the relay closest to the fault operates first, while upstream relays act as backups. Also principles of various protective relays and schemes including special protection. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. Combines protection, sensors, control power, and circuit breaker in a single package Typically added to a breaker close circuit to prevent accidental reclosure after a trip.
Read More
The CRD series relay is a protection device operating in a Fail Safe mode during normal monitoring conditions. This relay is used to disconnect transmission and feeder circuits when the current through them in a given direction exceeds a predetermined value.
Read More+48 22 538 72 19
ul. Postępu 14, 02-676 Warszawa, Poland