The CRD series relay is a protection device operating in a Fail Safe mode during normal monitoring conditions. This relay is used to disconnect transmission and feeder circuits when the current through them in a given direction exceeds a predetermined value.
Read More
If the circuit breaker does not trip, or the earth-leakage indicator does not change to yellow, check that the circuit breaker is energized. If the circuit breaker is energized correctly, and has not tripped or indicated the earth-leakage fault, replace the MicroLogic4 trip unit. The first reason is that the design configuration is different The design principle of the distribution system is to realize the step-by-step protection from the standard distribution. The leakage protection device works on the basis of leakage current detection, which is an effective safeguard measure for electric power at present. Therefore, it is of great significance to find the leakage position quickly and accurately, and deal with it in time.
Read More
The electromagnetic attraction protective relays are applicable in both AC and DC power and attract their poles towards the electromagnetic. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. Its main purpose is to safeguard electrical equipment like transformers, generators, and transmission lines from damage due to.
Read More
The 3 phase surge protection device keeps equipment safe by sending dangerous surges away from electronics. 3-phase power is a method of alternating current (AC) generation, transmission, and distribution that uses three electrical conductors, each carrying AC voltage of the same frequency and amplitude but offset by 120 degrees—one-third of a 360-degree cycle as shown in Figure 1—to provide that power. Abstract: To protect personnel, equipment, and maintain continuity of service for an electrical system, protection or fault interrupting devices are required. Adequate system designs allow for the system to withstand and isolate faults while not causing additional damage and/or outages. Its primary function is to limit transient overvoltages caused by lightning strikes or switching operations in the power grid, thereby. In practice, it's installed at the origin of a 3-phase supply (such as a distribution board or consumer unit) and.
Read More
The electromagnetic attraction protective relays are applicable in both AC and DC power and attract their poles towards the electromagnetic poles. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. Its main purpose is to safeguard electrical equipment like transformers, generators, and transmission lines from damage due to. An electrically operated switch like a relay plays a key role in controlling an electrical circuit through an independent low-power signal, otherwise used where a number of circuits should be controlled through the single signal.
Read More+48 22 538 72 19
+49 30 983 21 44
ul. Postępu 14, 02-676 Warszawa, Poland