The CRD series relay is a protection device operating in a Fail Safe mode during normal monitoring conditions. This relay is used to disconnect transmission and feeder circuits when the current through them in a given direction exceeds a predetermined value.
Read More
If the circuit breaker does not trip, or the earth-leakage indicator does not change to yellow, check that the circuit breaker is energized. If the circuit breaker is energized correctly, and has not tripped or indicated the earth-leakage fault, replace the MicroLogic4 trip unit. The first reason is that the design configuration is different The design principle of the distribution system is to realize the step-by-step protection from the standard distribution. The leakage protection device works on the basis of leakage current detection, which is an effective safeguard measure for electric power at present. Therefore, it is of great significance to find the leakage position quickly and accurately, and deal with it in time.
Read More
The electromagnetic attraction protective relays are applicable in both AC and DC power and attract their poles towards the electromagnetic. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. Its main purpose is to safeguard electrical equipment like transformers, generators, and transmission lines from damage due to.
Read More
The electromagnetic attraction protective relays are applicable in both AC and DC power and attract their poles towards the electromagnetic poles. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. Its main purpose is to safeguard electrical equipment like transformers, generators, and transmission lines from damage due to. An electrically operated switch like a relay plays a key role in controlling an electrical circuit through an independent low-power signal, otherwise used where a number of circuits should be controlled through the single signal.
Read More
In pole groundings, lightning protection wires are needed every 250 meters between the poles. Our light-ning and surge voltage protection systems are per-fectly matched to one another and to the requirements in the different zones – from the air-termination device, which must arrest the full energy of a lightning strike, through to fine power protection, which eliminates the last voltage. Lightning protection and grounding design for a car service station having dimensions 30. Values up to 25 ohms may be acceptable in some cases, but lower is always better.
Read More+48 22 538 72 19
ul. Postępu 14, 02-676 Warszawa, Poland