Causes of beam splitter failure
Exposure of the reinforcement and concrete to severe environmental conditions could lead to cracking of reinforcements.
Read More
Causes of Buried Optical Cable Failures
Underground fiber optic cable systems offer excellent protection and long-term reliability, but they are still vulnerable to various types of failure. Mechanical damage, environmental conditions, improper installation, and lack of testing are among the most common causes. Discover the most common underground fiber optic cable failures, their causes, and how to prevent damage in buried fiber networks.
Read More
Causes of Overvoltage on Switchgear Busbar
: Bus overvoltage is primarily caused by switching operations in the power distribution network, lightning strikes, faults in transmission lines, and resonant conditions within the electrical system. Because of this convergence, short circuits located on or near the busbar tend to have very high magnitude currents. My SRT 5kxli had a issue in which dc bus over voltage is occurred in logs and load dropped. This fault has several possible causes and this whitepaper explores each one, ofering solutions to ensure proper VFD operation. Disclaimer: Troubleshooting or servicing a VFD or any electrical equipment should only be performed by qualified personnel familiar with electrical safety practices. Abstract: Covered in this recommended practice is the protection of bus and switchgear used in industrial and commercial power systems.
Read More
Causes of discharge in tubular busbars
How It Works: A high voltage is applied to the busbar, and PD sensors detect the presence of discharges within the insulation. These discharges are localized and often occur due to voids, cracks, or contamination. Infrared diagnosis of busbar discharge involves temperature measurement, calculation of relative temperature difference (accounting for ambient temperature), and comparison with normally operating busbars. However, the research on this equipment is insuf cient because of the short application and the lack of technical digestion, which has resulted in many accidents. How do you check and maintain busbars? What are the faults of busbar? What is bus bar in DB? For complete safety instructions and precautions, always refer to the test equipment instruction manual. Busbars are critical components in electrical distribution systems, used to conduct large amounts of current and distribute power between electrical devices.
Read More
Electrification box causes wall resonance
The most likely culprit of this unexpected result was probably due to cavity resonance. The metal box tested formed a resonant cavity, where standing waves in the field were formed between opposite sides when the dimension between the sides of the box was a multiple of. Here, the capacitor bank and the grid inductance (transformer) are in parallel as seen from the harmonic source (the load). In my consulting work, I have noticed that radiated emission (RE) and radiated immunity (RI) have become much more pervasive issues for most of my clients. There are several reasons for this, which include the shift to more compact design, more portable products, as well as the fact that noise. Everything looks solid — until something inside the metal box starts misbehaving at a specific frequency, and nobody can explain why. It's one of the most underdiagnosed failure modes in EMC engineering, and it hits small RF shielded. Ferroresonance is a non-linear resonance phenomenon that can affect power networks. Considering the simplified circuit represented on Figure L29 (no PFC capacitors connected): The voltage distortion V h at the busbar level results from two different factors: voltage distortion U h present on the supply network due to non-linear loads outside of the considered circuit (incoming.
Read More